We size every Olivet, MI system to basin capacity and inflow rate, not a generic package.

Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Most Olivet, MI inspection requests get a response within a day or two.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.

We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Olivet, MI basement layouts.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.

Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.

"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Olivet Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Olivet Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Olivet Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Olivet Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Olivet, MI area's typical rainfall intensity.
If disruption is a major concern, we can discuss the baseboard channel alternative instead.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
Not sure if your basement needs full perimeter drain tile or a targeted fix? Call +1-866-476-1348 and we'll walk through it.



Zip codes we serve in Olivet, MI: 49076
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.